Claind NiGen LCMS - Electric Power Supply

Nitrogen Generator NiGen HF - NiGen LCMS
17
5.3. Drain
Not applicable to NiGen HF-0, NiGen LCMS 40-0 and NiGen LCMS 100
CONNECTION
• Locate the "DRAIN" outlet at the rear of the generator.
• Connect the condensation drain pipe (e.g., dia. 4 mm polyamide hose).
• Route the other end of the pipe into the condensate collection container.
m The condensation is expelled by bursts of compressed air. If using a
flexible hose, make sure it is properly secured.
5.4. Electric power supply
c For reasons of safety, the following instructions must be strictly ob-
served.
The electrical installation must comply with current standards, in particular re-
garding the protection line/ground wire.
c Recommendations for correct installation:
• do not use extension leads, adaptors or multiple sockets;
• always connect the protection/ground wire;
• the mains socket and switch must be located in an easily accessible position.
• if the provided power cable does not match the local plug configuration, the
proper power cable with the appropriate configuration must be obtained prior to
attempting to apply power to the unit.
CONNECTION
• Locate power cable connector at the rear of the generator.
• Before connecting the cable, ensure that the POWER switch is set to OFF.
• Connect the power cable supplied with the generator.