Claind NiGen LCMS - Disassembly and Transport; Disassembly Procedure

Nitrogen Generator NiGen HF - NiGen LCMS
19
6. Disassembly and transport
6.1. Disassembly
• Stop the generator (par 7.6.);
• wait for depressurization (about a minute);
• switch off the generator (par. 7.7.);
• disconnect the electric power cable;
• only for NiGen HF-1 and NiGen LCMS 40-1 , depressurize the air tank, removing
the air outlet plug (par. 3.3.2.) and acting on the air outlet pressure regulator as
described at par. 7.9.2. Plug again the air outlet;
• carefully detach the pneumatic connections.
6.2. Transport
e Remember that during transport the generator must always remain in a vertical
position.
If conserved, use the original packaging; otherwise use a pallet of adequate di-
mensions to hold the generator, affixing instructions in visible locations, such as:
THIS WAY UP, KEEP IN VERTICAL POSITION.