Clarion CMV1 User Manual

36
CMV1
English
Owner’s manual
7. SYSTEM SETTINGS
Audio Settings
You can adjust a audio effect or tone quality to
your preference.
● Adjusting the bass
2-1. Select “Bass”.
3-1. Press the [ENTER] button.
3-2. Turn the [UP/DOWN] knob to adjust the
gain from –7 to +7 (The factory default
setting is “0”).
3-3. Press the [RETURN] button to return to the
previous mode.
● Adjusting the treble
2-1. Select “Treble”.
3-1. Press the [ENTER] button.
3-2. Turn the [UP/DOWN] knob to adjust the
gain from –6 to +6 (The factory default
setting is “0”).
3-3. Press the [RETURN] button to return to the
previous mode.
● Adjusting the balance
2-1. Select “Balance”.
3-1. Press the [ENTER] button.
3-2. Turn the [UP/DOWN] knob to adjust the
balance of the right and left speakers.
* The factory default setting is “Center”
(center) (Adjustment range: LEFT 12 to
RIGHT 12 (left 12 to right 12)).
3-3. Press the [RETURN] button to return to the
previous mode.
● Adjusting the fader
2-1. Select “Fader”.
3-1. Press the [ENTER] button.
3-2. Turn the [UP/DOWN] knob to adjust the
balance of the rear and front speakers.
* The factory default setting is “Center”
(center) (Adjustment range: REAR12 to
FRONT12 (rear 12 to front 12)).
3-3. Press the [RETURN] button to return to the
previous mode.
● Adjusting the non-fader volume
Adjust volume output from the unit’s non-fader
output terminal.
2-1. Select “Non Fader Volume”.
3-1. Press the [ENTER] button.
3-2. Turn the [UP/DOWN] knob to increase or
decrease volume.
* The factory default setting is “0”.
(Adjustment range: -6 to +6)
3-3. Press the [RETURN] button to return to the
previous mode.
● Setting the BBE MP
(Sound Enhancement and Restoration
for compressed audio files)
BBE MP (Minimized Polynomial Non-Linear
Saturation) Process improves digitally
compressed sound, such as MP3, by restoring
and enhancing the harmonics lost through
compression. BBE MP works by regenerating
harmonics from the source material, effectively
recovering warmth, detail and nuance.
* This fuction is effective for the audio files in the
USB mode and the iPod mode (while the iPod
Output Formart is set to “Digital”).
* The factory default setting is “OFF”.
2-1. Select “BBE MP”.
To change audio setting
1. Press the [AUDIO] button to switch to the
audio adjustment selection display.
2. Then turn the [UP/DOWN] knob to select
the audio adjustment mode.
Each time you turn the [UP/DOWN] knob,
the sound adjustment mode changes as
following order:
“Bass” ↔ “Treble” ↔ “Balance” ↔
“Fader” ↔ “Non Fader Volume” ↔
(“BBE MP”)
* “BBE MP” can be selected only in the USB/
iPod mode.
3. Press the [ENTER] button.
4. Turn the [UP/DOWN] knob to adjust the
selected audio mode.
5. After completing settings, press the
[RETURN] button to return to the previous
mode.
280PE3161BA_EN.book Page 36 Thursday, March 12, 2009 1:12 PM

Clarion CMV1 Specifications

General

Brand	Clarion
Model	CMV1
Category	Marine Equipment
Language	English