13
CMV1
English
Owner’s manual
After connecting an USB device
The system will automatically be switched to the
relevant source media mode according to the
USB device connected, and start playback.
When an iPod is connected:
The system is switched to the iPod mode. See
“iPod Operations” (page 30).
When an USB memory is connected:
The system is switched to the USB Memory
mode. See “USB Memory Operations” (page 33).
Note:
• Never insert foreign objects into the USB
connector.
• Always insert the USB media device fully into the
connector. Incomplete connections may cause the
device not to be recognized.
Disconnecting an USB media
device
1. Confirm that data transfer is not performed on
the USB media device.
For the method to confirm it, see the operation
manual of your USB media device.
2. Remove the USB media device from the USB
connector.
CAUTION
Be sure to disconnect the USB media device
while the engine is running.
Otherwise, it may result in loss or damage to
data on the USB media device. Do not stop
the engine when the USB media device is
connected.
Note:
• When turning on the ACC power with no USB
media device connected, “Media Check” may be
displayed on the screen if the USB mode is
selected.
Visual Output Function
About the Visual Output function
This function is available when a external monitor is connected to the rear Visual Output terminals.
The Visual Output function is a function that assigns separate video output to this unit and the optional
rear monitor. Therefore, the other people are allowed to enjoy the video from the source played on the
front panel of this unit.
Note:
• If the external rear monitor’s video image is disturbed, maybe because this unit’s video system is not set
correctly. Please set this unit’s video system correctly.
Connecting/Disconnecting an USB Media Device
280PE3161BA_EN.book Page 13 Thursday, March 12, 2009 1:12 PM
To Next Page
Loading...
