Safety Precautions
80
MAX973HD
English
INSTALLATION AND WIRE
CONNECTION MANUAL
Wire connection notes
CAUTION
• Connect cables appropriately. If a wrong
connection is made, this may cause a fire or
accident.
• When passing cables through the body of
the vehicle, use non-conductive grommets.
• If the coatings of the cables are worn out by
rubbing, this may cause an accident, fire or
a short circuit.
• After wiring cables, fix them with insulation
tape.
• Be sure to switch off the vehicle when
connecting or disconnecting cables to/from
the unit, otherwise an electric shock, injury
or accident may occur.
WARNING
• Loom all cables according to the
instruction manual so as not to hinder
operation.
• Wire the connecting cables away from
high temperature areas. If the coatings of
the cables melt, it may cause an accident/
fire by a short circuit. Take care when
wiring in the engine compartment.
• When wiring the connecting cables in a
vehicle with an airbag system, never feed
the cables through a place where it may
interfere with the operation of the airbag.
If the airbag not operating correctly in an
emergency, it may cause increased
injury.
To Next Page
Loading...
Need help?
General
