3.7 Running a Simulation
To run a simulated navigation that demonstrates the planned route, perform the following
steps:
1. Tap
on the Navigation view to access the Navigation menu.
2. In the Navigation menu, tap
.
3. Tap
.
4. Tap
. The simulation starts from the starting point of the route and
leads you through the whole planned route using a realistic speed.
(optional) You have the following controls during the simulation (the control buttons
disappear after a few seconds but you can open them again if you tap the map):
•
: Jump to the next route event (manoeuvre).
•
: Pause the simulation.
•
: Jump to the previous route event (manoeuvre).
•
: Tap to increase the speed of the simulation to 4, 8 or 16 times faster.
Tap again to return to normal speed.
NX405E English 59
To Next Page
Loading...
