Set the verbosity of the voice instructions, that is how much they tell and
how often they speak.
• Minimal: the voice instruction is given once right before the next
manoeuvre.
• Medium: the voice instruction is given when approaching the next
manoeuvre and it is repeated right before the manoeuvre.
• Verbose: the voice instruction is given first relatively far from the
next manoeuvre, it is repeated when approaching the next turn,
and it is repeated again right before the actual manoeuvre.
Allow reading out a quick summary of the route whenever a route is
calculated.
Allow reading out information about the country you have entered, when
you cross country borders.
Allow reading out real-time traffic messages.
Allow announcing system messages.
4.3.3 Warnings settings
You can enable and modify the following settings:
NX405E
is able to warn you if you exceed the current speed limit. This
information may not be available in your region, or may not be fully
correct for all roads on the map.
Th
e maximum speed set in the vehicle profile is also used for this
warning. NX405E alerts you if you exceed the pre-
legal speed limit is higher.
This setting lets you decide whether you wish to receive visible and/or
audible warnings.
The following warning types are available:
• Visual warning: the current speed limit is shown on the map
when you exceed it.
• Audio and Visual warning: besides the current speed limit being
shown on the map, you also receive a verbal warning when you
exceed the speed limit with the set percentage.
If you prefer to see the speed limit sign on the map all the time
(normally, it is shown only if you exceed the limit), you can set it here.
You can also set the relative speed above which the application initiates
t
he warning by adjusting a slider. The value can be different within and
outside towns.
NX405E English 75
To Next Page
Loading...
Need help?
General
