42 NX405E
English
English
Owner’s Manual
English
Service Scan
When you want to update the list with the current
services in Ensemble List or PTY List, please perform
Service Scan.
1. Touch the option button [
] to open option menu
display.
2. In Option Menu, touch the [Start] button.
3. Touch the [OK] button to start updating the service
list, touch the [Cancel] button to cancel this operation
then back to previous menu.
4. When scanning the services, this image will display.
Notes:
After service scan, currently available services will be
updated in the Ensemble List and PTY List.
DAB Band
When touch the DAB band button, the band will change
as below DAB1->DAB2->DAB3->DAB1…
Preset Scan
Preset Scan tunes to the Services stored in the preset
list in order.
1. Touch the [DAB1/2/3] button to select the desired
band.
2. Touch the [
] button to start the Preset Scan.The
unit starts scanning each service for playing
10 seconds sequentially.
3. When the desired service is tuned in, touch the[
]
button again to stay in that service.
Service Link Setting
You can select Service Link mode from On or OFF. If this
setting is set to On, and current Service signal gets
weak, it is to be linked to the service with better signal.
1. Touch the option button[
] to open option menu
display.
2. Touch the [
] button to switch On or OFF.
Note:
If the service is linked to the FM station, the FM indicator
will be turned on.
To Next Page
Loading...
Need help?
General
