Why cannot pair the Bluetooth enable device with the Clarion NZ501E Car Receiver?
If you cannot pair a Bluetooth enabled device with your Clarion Car Receiver, the device may not support the profiles required for the system, so use another device to connect. Also, the Bluetooth function of the device might not be enabled, so refer to the user manual of the device for how to enable the function.
Why is the Clarion NZ501E Car Receiver remote control unit not working?
If the remote control unit for your Clarion Car Receiver isn't working, it could be due to direct sunlight falling on the light-receptive part of the unit. Also, the battery of the remote control unit may be dead or missing. Check the battery of the remote control unit.
What to do if the Clarion Car Receiver USB device cannot be inserted?
If your Clarion Car Receiver won't allow you to insert a USB device, it might be because the USB device has been inserted in the wrong direction. Reversing the connection direction of the USB device, try it again. Also, the USB connector might be broken, so replace with a new USB device.
Why is Clarion Car Receiver display dark?
If the display on your Clarion Car Receiver is dark, the brightness control might be too low. Adjust the brightness properly. The operating condition might not be good, so set to an appropriate temperature (25 or so) and check it again. The headlight of the vehicle might be lit (The display is made dark at night to prevent the glare. When the headlight of the vehicle is lit in the daytime, the display gets dark).
Why is there no sound heard and no file display on file list on Clarion Car Receiver?
If there is no sound and no file display on the file list of your Clarion Car Receiver, it could be because no MP3/WMA file is stored in the USB device. Store these files properly in the USB device.
Why is the image disturbed when the VTR is connected to Clarion NZ501E?
If the image is disturbed when the VTR is connected to your Clarion Car Receiver, the NTSC/PAL setting might be improper. Set the AUTO/PAL/NTSC properly according to the VTR.
Why video images are not displayed on Clarion NZ501E?
The video images may not be displayed on your Clarion Car Receiver because the parking brake is not engaged. Check that the parking brake is engaged.
Why is there no power on my Clarion NZ501E?
If your Clarion Car Receiver isn't powering on and no sound is produced, it could be due to a blown fuse. Replace it with a fuse of the same amperage. If it blows again, consult your store of purchase. Another cause might be incorrect wiring, in which case you should consult your installation center.
What to do if Clarion Car Receiver buttons don't work and the display is inaccurate?
If the buttons on your Clarion Car Receiver aren't responding and the display is inaccurate, the microprocessor may have malfunctioned. To fix this, press the reset button with a thin rod. Note that pressing the reset button will turn off the power and clear stored radio frequencies and titles.
General| Brand | Clarion |
|---|---|
| Model | NZ501E |
| Category | Car Receiver |
| Language | English |
To Next Page
