Clarion NZ502E - 5. REMOTE CONTROL

10 NZ502E
English
English
Owner’s Manual
English
Owner’s Manual
5. REMOTE CONTROL
Replacing the batteries
1.Presstheretentiontabandpulloutthebatterytray
and remove the old battery.
2. Insert the new CR2025 battery and slide the battery
tray back in the remote control the same direction
that you removed it.
 Pleaseensurethetrayisinsertedinthecorrect
direction.
Note:
Using batteries improperly can cause them to explode.
Take note of the following points:
•Whenreplacingbatteries,replacebothbatterieswith
new ones.
•Donotshort-circuit,disassembleorheatbatteries.
•Donotdisposeofbatteriesintoreorames.
•Disposeofspentbatteriesproperly.
WARNING
Lithium (CR) battery contain
Perchlorate
Dispose of discharged batteries properly.
Signaltransmitter
Operating range : 30°in all directions
[ / ]
[0-9]
[SRCH]
[BACK]
[ , , , ]
[TITLE]
[ ], [ ]
[ZOOM]
[MUTE]
[AUDIO]
[POWER / SRC]
[VOLUME]
[SET]
[PIC]
[TA]
[RPT]
[ ], [ ]
[SUB.T]
[OPEN]
[ANGLE]
[NAVI / AV]
[MENU]
[BAND]
[ROOT]
[ENT]