Clarion NZ502E - Anti-Theft Code Setup

49NZ502E
English
English
Owner’s Manual
English
Owner’s Manual
Thismenuincludes:Balance,Fader,SelectEQ,Sub
WooferCtrl,SubWooferPhase,HighPassFilter,low
PassFilter,AmpCancelandMagnaBassEX.
Balance: Choose the desired volume for left and right
speaker.
Fader: Choose the desired volume for front and rear
speaker.
Select EQ:Choosethedesiredmode:BassBoost,
Impact, Excite, Custom and OFF.
Sub Woofer Ctrl: Choose the desired sub woofer gain
from 0 to 14.
Sub Woofer Phase: Choose the sub woofer phase
normal or reverse.
High Pass Filter: Choosethehighpasslter
through/55Hz/85Hz/120Hz.
Low Pass Filter:Choosethelowpasslter
through/62Hz/95Hz/135Hz.
Amp Cancel:Choosetheamplieraudiooutputon
or off.
Magna Bass EX: Choose the loudness on or off.
Navigation Setup Menu
Thismenuincludes:GPSTime,NaviInterrupt,and
VoiceGuidance
GPS Time:Setthesystemtimetobesynchronized
withGPSlocaltimeornot.
Navi Interrupt:Therearethreechoose:On/Popup/
Off.“On”:ThenavigationscreenwillcovertoAV
screenwhenreachingsomekeypoint.“Popup”:When
small turn info window will pop up in the top of the
AVscreentoindicatethekeypoint.“Off”:Turnoffthis
function.
Voice Guidance: Enable or disable the navigation
voice guidance.
Voice Guidance Mix: There are two choose: On/Off.
“On”:Thenavigationvoiceguidancewillplayatthe
sametimeandthevoiceofthecurrentsource.“Off”:
Onlythenavigationvoiceguidance.(VoiceGuidance
On).
Others Setup Menu
Thismenuinclude:SetPassword;Parentalcontrol,
AudioLanguage,Subtitle
Language,PTYLanguage,ChangeLanguage,
Blinking,TSCalibrate,andLoadFactory.
Set password:SetthepasswordforDVDparental
control.
Parental control:Settheratingoftheage.Itcontains
KidSafe/G/PG/PG-13/PG-R/R/NC-17/Adult.
Audio Language:SettheLanguageforDVDAudio.
Subtitle Language:SettheLanguageforDVDsubtitle.
PTY Language:SettheLanguageforPTYname.
System Language: SettheLanguageforsystem
screen.
Blinking LED:SelecttheblinkingLEDOn/Off.
Screen Calibrate: ThefunctionofitistoselecttheTS
CalibrateYESorNO.
Factory Default: The function is to select to load
factory default or not.
Set the Anti-Theft code
1. If your unit is unlocked, hold the [ ] button
morethan2seconds,thentheAnti-Theftsetting
modewilldisplay.Userscanchangeanti-theftcode.
Click[Yes],thenumericalkeypadisdisplayed.Enter
thenewpasswordtwice,thenanti-theftcodeisset
and your unit is secured.