Clarion NZ502E - Wiring Cautions and Fuse Replacement

60 NZ502E
English
English
Owner’s Manual
English
Owner’s Manual
6. Cautions on Wiring
1.Besuretoturnthepoweroffbeforewiring.
2.Beparticularlycarefulwhereyouroutethewires.
 Keepthemwellawayfromtheengine,andexhaustpipe,etc.Heatmaydamagethewires.
3. If the fuse should blow, check to see if the wiring is correct.
 Ifafuseisblown,replaceitwithanewoneofthesameamperageratingastheoriginal(15AFUSE).
4.Toreplacethefuse,removetheoldfuseonthebackoftheunitandinsertthenewone.(Figure8)
NOTE:
There are various types of fuse holder. Do not let the battery side touch other metal parts.
Figure 8
Fuse(15AFUSE)
After the connection, fix the cord by a clamp
or insulation tape for protection.
Fuse holder
CAUTION