1
CONTENTS
SUBJECT PAGE
1.0 INTRODUCTION 4
1.1 IDENTIFICATION/NAMEPLATE 4
1.2 SAFETY/CAUTION/WARNINGS 5
1.3 PRECAUTIONS FOR WELDING 9
2.0 INSTALLATION/OPERATION 10
2.1 TYPICAL INSTALLATION 10
2.2 ENGINE STORAGE 10
2.2.1 Storage Less than 1 year 10
2.2.2 Extended Storage Maintenance Procedure 10
2.2.3 Coolant System 11
2.2.4 Removal from Storage 11
2.3 INSTALLATION INSTRUCTIONS 12
2.4 SPECIFIC FLYWHEEL COUPLING ALIGNMENT INSTRUCTIONS 13
2.4.1 Driveshaft 13
2.5 WEEKLY TEST 16
2.6 STARTING/STOPPING THE ENGINE 16
2.6.1 To Start Engine 16
2.6.1.1 Start Engine for Test Purposes (“Soft Start”) 16
2.6.2 To Stop Engine 17
2.6.3 Describing Engine Gauge Panel 18
2.6.3.1 ECM Selector Switch and Primary/Alternate Electronic Control Modules (ECM’s) 18
2.6.3.2 Dual ECM Automatic Switching 18
2.6.3.3 Programming ECM with Automatic Switching Device 19
2.6.3.4 Using Power View Gauge 19
3.0 ENGINE SYSTEMS 29
3.1 FUEL SYSTEM 29
3.1.1 Diesel Fuel Specification 29
3.1.2 Bleeding the Fuel System 30
3.1.2.1 C32 Engine Series after Filter Change 30
3.1.2.2 C32 Engine Series After Engine was Run Out of Fuel 31
3.1.3 Changing Fuel Filters 31
3.1.3.1 C32 Engine Series 31
3.1.4 Fuel Tanks 32
3.2 AIR/EXHAUST SYSTEM 32
3.2.1 Ambient Conditions 32
3.2.2 Ventilation 32
3.2.3 Standard Air Filter 32
3.2.4 Crankcase Ventilation 33
To Next Page
Loading...
Need help?
General
