EasyManua.ls Logo

Cleanmate S2000 PRO MAX - Troubleshooting Dust Collector Faults; Common Dust Collector Faults and Solutions

Cleanmate S2000 PRO MAX
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Item
The blue light flashes all the time in
the standby state of the dust
collection station
APP and voice prompt that dust
bag is not installed
APP and voice prompt abnormal
wind pressure, please cover the
dust cover
APP and voice prompt abnormal
wind pressure, please clean up
the abnormal air duct
APP and voice prompt dust
collection station is abnormal,
please contact
Damaged sensor inside dust collection
station
After-sales maintenance
The dust bag opening is not opened,
and the air inlet under the dust
collection station is blocked
Check the dust bag opening and clean
the lower air inlet
The upper cover of the dust collection
station is not covered
Press the upper cover of the dust
collection station
Not placed in the dust bag or the dust
bag is not placed in the card slot
Put it in the dust bag correctly
The switch in front of the dust collection
station does not rebound or there are
magnetic substances in the side
Clean the front magnet by manually
shaking the front impact switch
Fault Prompt Possible cause Solution
Trouble shooting dustcollector
If there is an abnormal state during the operation of the dust collection station, please refer to the following table for investigation.
36

Related product manuals