7
Fig 1: This is the recommended antenna installation for the best performance.
Fig 2: Top of the Antenna 1 is aligned with an electric line, this will hinder the reception
quality and it is not recommended.
Fig 1 Fig 2
3 Clean the windshield.
Ensure the antenna location on the windshield is clean and free of dirt, water, and other
substance which will help the antenna adhere to your car windshield properly. Clean the glass
with alcohol prep pad, and wait until the surface is completely dry before attaching the
glass-mount DAB antenna.
Do not use a cleaner with surfactant to clean the windshield because Antennas 1 & 2
and the Signal Booster may not stick to the glass.
4 Attach the glass-mount antenna to the windshield.
4.1 As it is designed to be attached once only, if the antenna is removed, it will not adhere
again; therefore, it is recommended that you try fitting the antenna on the chosen
location first before attaching the antenna permanently.
4.2 Gently peel off the adhesive separator of Antenna 2 and paste it on the inside of the
windshield on the chosen location, press and rub to bond it to the glass.
4.3 Repeat step 4.2 for the Signal Booster.
4.4 Repeat step 4.2 for the Antenna 1, allow for a small slack of Antenna 1 before attaching
it to the glass (see below). This is to prevent over pressed the joint, between the
Antenna 1 and the Signal Booster, and breaks the Antenna 1.
Booster
Booster
To Next Page
Loading...
Need help?
General