59
EVH-X SPACE 2.1 - 12.1
M0SM10N17-03
Disconnection
Before performing any intervention, read the
warnings in the Maintenance chapter.
Avoid leak or spills into the environment.
Before disconnecting the unit, the following must be
recovered, if present:
• refrigerant gas
• anti-freeze solutions in the water circuit
When awaiting dismantling and disposal, the unit
can also be stored outdoors, as bad weather and
rapid changes in temperature will not cause
damage to the environment, if the unit's electric,
cooling and hydraulic circuits are integral and
closed.
CE WEEE DIRECTIVE
The manufacturer is registered on the EEE National
Register, in compliance with implementation of
Directive 2012/19/EU and relevant national
regulations on waste electrical and electronic
equipment.
This Directive requires electrical and electronic
equipment to be disposed of properly.
Equipment bearing the crossed-out wheelie bin mark
must be disposed of separately at the end of its
life cycle to prevent damage to human health and
to the environment.
Electrical and electronic equipment must be
disposed of together with all of its parts.
To dispose of “household” electrical and electronic
equipment, the manufacturer recommends you
contact an authorised dealer or an authorised
ecological area.
“Professional” electrical and electronic equipment
must be disposed of by authorised personnel
through established waste disposal authorities
around the country.
In this regard, here is the definition of household
WEEE and professional WEEE:
WEEE from private households: WEEE originating
from private households and WEEE which comes
from commercial, industrial, institutional and other
sources which, because of its nature and quantity,
is similar to that from private households. Subject
to the nature and quantity, where the waste from
EEE was likely to have been by both a private
household and users of other than private
households, it will be classed as private household
WEEE;
Professional WEEE: all WEEE which comes from
users other than private households.
This equipment may contain:
refrigerant gas, the entire contents of which
must be recovered in suitable containers by
specialised personnel with the necessary
qualifications;
• lubrication oil contained in compressors and in
the cooling circuit to be collected;
• mixtures with antifreeze in the water circuit, the
contents of which are to be collected;
•
•mechanical and electrical parts to be separated
and disposed of as authorised.
When machine components to be replaced for
maintenance purposes are removed or when the
entire unit reaches the end of its life and needs to
be removed from the installation, waste should be
separated by its nature and disposed of by
authorised personnel at existing collection centres.
12 DECOMMISSIONING
To Next Page
Loading...
Need help?
General
