MAN.234 Rev.6 ENG - Use and maintenance manual S19HD page 21 of 126
The ignition of the endothermic engine can also be
carried out with the radio/wired control. Using it on
the ground or in the basket:
• turn the SK key to position 1;
• move the lever 8 in the Picture 8 upwards,
present on the left side of the radio/wired con-
trol under the joystick J1;
• in this case, the green light 5 (Picture 4a) will
light up on the switching on/off station to signal
the correct power supply of the machine.
To switch off the endothermic engine, you can alter-
natively:
• turn the SK key all the way to the left on posi-
tion 0;
• lift the lever 8 in the Picture 8;
• press, in emergency situations, one of the
emergency buttons on the machine (par.
4.5.1).
3.1.2 Switching on/off the electric en-
gine (*optional)
On the machine, it can also be provided an auxiliary
electric engine (*optional).
If you choose to use it:
• connect the 110/120/230 V socket to the near-
est electrical source;
Picture 6: power line socket.
• from the radio/wired control, start the engine
by pushing the lever 8 in Picture 8 downwards;
• the power supply is signaled by the lighting up
of the green led 5 (Picture 4a) on the switching
on/off station.
To switch off the electric* engine, it will be enough
to alternatively:
• turn the SK key all the way to the left on posi-
tion 0;
• lower the lever mentioned above;
• press, in emergency situations, one of the
emergency buttons provided on the machine
(par. 4.5.1).
To Next Page
Loading...
