MAN.234 Rev.6 ENG - Use and maintenance manual S19HD page 7 of 126
1.4 TÜV certification
C.M.C. s.r.l. states under its own responsibility that
S19HD PRO was designed and produced in com-
pliance with US standards ANSI/SAIA A92.20:2020
and that the machine is identical to the model sub-
mitted to control and test for the “TÜV certification”
by TÜV SÜD America Inc.
TÜV SUD America Inc. is an OSHA recognized
NRTL and a Standards Council of Canada accredit-
ed certification body.
1.5 Classification
The mobile elevating work platform (MEWP) S19HD
PRO belongs to group B: the vertical projection of
the center of the area of the MEWP in different plat-
form configurations specified by the manufacturer
can be outside the tipping lines (EN 280 par. 1.4 -
ANSI/SAIA A92.20 par. 3).
As for the displacement, it belongs to type 1: travel-
ling is only allowed with the MEWP in its transport
configuration or in the stowed position (EN 280 par.
1.4 - ANSI/SAIA A92.20 par. 3).
1.6 Loading cycles
The machine is expected to live for 40.000 working
cycles
(i.e. 10 years, 40 weeks per year, 20 hours
per week, 5 cycles per hour).
Within this term, the machine must undergo at
least 2 (two) in-depth checks (structural, mechan-
ical, electric, elements, etc.), in case of heavy uses
(frequent use at the performance limit, unfavourable
environmental conditions such as steel systems,
paper mills and so on) it is better to increase the
checks. Anyway, it is advisable to have the state
of the machine checked by the manufacturer
factory or by an authorized assistance point, at
least every 1500 – 2000 working hours or once a
year.
Loading cycle: cycle starts from the access posi-
tion, continues performing the work and finishes re-
turning to the access position.
To Next Page
Loading...
