MAN.234 Rev.6 ENG - Use and maintenance manual S19HD page 64 of 126
During the normal use of the platform, it is
absolutely forbidden to use electronic instru-
ments which do not meet the requirements of
the directive 72/245/CE and its following
amendments: the additional electronic in-
struments could impair good functioning of
the platform electronic components.
4.7.6 At the end of the works
➔ Before moving the machine, check that the
MEWP aerial part is set in the transport posi-
tion: check that the pantograph is on its own
support, that the telescopic boom is withdrawn
and rests on its own support;
➔ Before moving the machine, check that all the
outriggers are completely withdrawn and
blocked, that they are set in the transport posi-
tion, with the plates completely lifted.
➔ Park the MEWP in the storage location.
4.8 Safety devices
The machine is equipped with safety de-
vices designed to prevent the occurrence
of dangerous situations for the operator.
Before starting any operation, it is im-
portant that the operator checks the per-
fect functioning of these devices.
The non-functioning of a safety device,
caused by a failure or tampering, can
cause serious injury damage to the ma-
chine and consequently endanger life op-
erator. The manufacturer has designed
the machine and its devices in order to
guarantee the maximum safety for its cus-
tomers; however, the devices must be
checked periodically as described in this
manual and must never be tampered with.
Do not intervene on your own safety de-
vices. In case of tampering, the manufac-
turer declines all responsibility about any
accidents attributable to these interven-
tions.
To Next Page
Loading...
