MAN.234 Rev.6 ENG - Use and maintenance manual S19HD page 97 of 126
Any operation requiring interventions on
the components of the machine shall be
carried out by authorized and trained
staff.
Non-authorized staff can’t replace com-
ponents. Many components of the MEWP
have been calibrated: a correct calibration of
these parts (which is possible only in C.M.C.
or in authorized workshops) is necessary to
ensure the safety of the machine.
8.16.1 Remote Connection System
(*optional)
The remote connection system is composed of an
electronic box (Picture 87) mounted on the chassis
box.
Picture 87: remote connection system.
Following the remote connection procedure:
1. Ensure that the M12 socket on the remote
connection box is correctly connected to the
M12 plug of the electric box mounted on the
chassis;
2. Share your internet wireless network with the
remote connection device in free mode (with-
out password);
3. Lift the connection remote switch L on the
switching on/off box (Picture 88):
To Next Page
Loading...
