MAN.243 Rev.5 ENG - Use and maintenance manual S28 page 53 of 138
Picture 45: travel block bypass.
3. Activate the black ON/OFF lever inside.
The bypass, at this point, will be active and the operator
will be able to take the machine back to the conditions
prior to the block (travel in the original direction), until
stopping the previously activated acoustic warning.
C.M.C. DECLINES ANY TYPE OF RESPONSIBILITY
TO THE OPERATOR. THE MANUFACTURER HAS
CLEARLY ESTABLISHED TWO ACOUSTIC
WARNING THRESHOLDS, IN ORDER TO FULLY
INFORME THE USER ABOUT THE DANGERS DUE
TO THE NON-RECOMMENDED ACHIEVEMENT OF
19° LIMIT.
4.4 MEWP use procedures
The machine is equipped with the "SCS System" (Self
Control System) which allows:
• automatic stabilization,
• automatic speed control,
• automatic closing of the aerial part.
The following procedures shall be carefully
carried out in the correct chronologic order.
If full lithium version (*optional), before any
work start, check the battery charge level. It is
necessary to have at least 75% of battery charge,
otherwise it is advisable to charge them before
working.
4.4.1 Placement on the work area
1. Start the endothermic/electrical engine using
the supplied engine ignition key (Picture 4).
2. Identify the work area, which is nearest to the
workplace, and reach it by machine
handlings, using travel buttons (par. 4.3.3).
C.M.C. obligates to use the remote travel
controls, in order to ensure the travel
operations in complete safety.
To Next Page
Loading...
Need help?
General
