Software ver. CVPCA30E_1 44
End of Program/Infusion and Bag Change
Once the infusion had reached to an end (Pre-set
volume was infused), an alarm sounds and display
will show:
The alarm will stop after 4 beeps. The pump will
show the pre-set KVO rate (see “Change Set Up).
The alarm will sound again every 4 minutes, until
the user changes bag or stops the pump.
To prime the set:
To Prime the set (may be necessary if you have changed the set or if you are
using a set with a drip chamber):
If in fact necessary, press twice.
Select Change Bag and press .
NOTE: If using an infusion set with drip chamber, change to a new infusion bag,
but make sure that the drip chamber is half filled and there is no air in the
administration set.
To Next Page
Loading...
