Software ver. CVPCA30E_1 20
Operating the BodyGuard® PCA Pump
NOTE: Before using the BodyGuard® for the first time please ensure you have
carried out the 'pump operation tests’ as detailed in the previous
chapter. These tests should be carried out periodically to ensure all
systems are functioning correctly.
Before performing any of the set-up & period tests or to operate, program or
configure the pump you will need to access the pump using the security codes. As
the BodyGuard® 575 is designed for pain management therapies the pump has
several levels of security to ensure safe set up and administration of pain protocols
and to prevent idle or malicious tampering.
Access Codes & Keypad Lock
To operate, program and configure the BodyGuard® PCA Infusion pump three
Access Codes are required.
All codes and codes levels can be modified and controlled from technician menu.
Level One 700 Allows user to run pre-set protocols and titrate
infusion rate (within pre-set protocol limits).
Level Two * Allows authorized users to deliver Clinician Activated
Bolus or loading dose.
Level Three ** Allows users to set up or modify standard infusion
protocols & change pump configuration parameters in
‘Change Set Up’.
* / ** refer to senior clinical or lead service personnel.
Additionally, a technician’s code is necessary to access the technician menu but
this is only provided to fully trained & authorized electrical biomedical engineering
departments.
To Next Page
Loading...
Need help?
General
