Software ver. CVPCA30E_1 46
Fix the obstruction in the I.V. line and press to continue.
Review Set Up
Selecting ‘Review Set Up’ from the main menu and pressing allows you to
scroll through, select and view any of the default parameters or events history.
Simply scroll to a parameter you wish to view and press _ .
In this mode you can only view the parameters but cannot change any of the
values which users can configure.
Change Set Up
For users to configure the variable default settings they must use the Technicians
Access Code. To change default settings follow these steps: -
1. From the main menu select ‘Change Set Up’ and press .
2. Enter the relevant access code & press again.
NOTE: Not all default parameters mentioned in the above table can be
configured by the user. Only those highlighted yellow in the table are
changeable at a local level.
3. Scroll through the parameters to the one you wish to change and press
. If it is a numeric value simply key in the new value and press
_. If it is an optional value, scroll through the options and press _ _to
confirm your choice.
4. Once the user has changed or confirmed a parameter the pump returns to
the ‘Restart Pump’ choice. Press _to exit or scroll down to
view/change another parameter repeating step 3 above.
To Next Page
Loading...
Need help?
General
