45
STARTUP REPORT
Please fill out completely and return to the factory to validate warranty.
CUSTOMER AND MACHINE INFORMATION
CUSTOMER FACTORY SHIP DATE / /
ADDRESS DATE STARTED UP / /
CITY/STATE MODEL NUMBER
PHONE SERIAL NUMBER
WRITTTEN BY HOURS ON MACHINE Hrs.
MACHINE INFORMATIONS AND INITIAL STARTUP
Machine Location – indoors outdoors
if outdoors, protected from rain? Yes No .
Approx. ambient temperature______ adequate ventilation? - Yes No .
Did you check for correct rotation? Yes No
Nameplate amperage for voltage used ______
Incoming Voltages
Full load amperage at _________ PSIG
Unload amperage at _________ PSIG
Is the machine on a level and stable surface? Yes
Was a flexible connector used to connect piping? – Yes No .
Approx. time spent during startup procedure ___________ Hrs.
Did you advice customer on operation and maintenance of machine? Yes No .
Application and installation comments:
___________________________________________________________________________________________________
Machine Sold By(Company) __________________ Sales Person ___________________________
Startup performed by _______________ Date _________________________________
THERE IS NO WARRANTY WITHOUT THIS REPORT!
To Next Page
Loading...
