10.10 Listen
The default mode is “Track” mode, dial the device, reply position
Command: listen+password, switch to Listen mode, dial the device, enter call
Command: tracker+password, restore to Track mode
10.11 ACC ON/OFF Alert
This function is OFF by default. If tracker detect “ignition on” signal from ACC wire (white wire),
tracker will send “ACC on+latitude& longitude” to authorize number to tell you the vehicle has been
started. When detect “ignition off” signal, it will send “ACC off+ latitude & longitude” to tell you
the vehicle has been stopped.
Turn on
：
ACC+password
，
response
：
ACC ok
Turn off
：
noACC+password
，
response
：
noACC ok
10.12 SIM Card Balance Enquiry
Way1
Command: balance+password+space+operator number+space+code
The device will forward the received text message from the operator to the sender of the command
Way 2
Command: forward+password+space+operator number
When the network operator sends a text message to remind you to top up your sim card, the tracker
will forward the notification message to the authorized number
10.13 Check Status
Command: check+password, Response: Battery, GPS signal, GSM signal, GPRS status, APN, UP, IP,
Port etc.
10.14 IMEI Inquiry
Command: imei+password, response: the imei of your device.
10.15 Time zone setting
The device automatically synchronizes the local time zone. If the time is wrong, you need to set the
time zone.
Command: time+space+zone password+space+time zone, reply: time ok
10.16 Reset Hardware
Command: reset+password, response: reset ok
To Next Page
