means unlimited times.
Cancel: nofix+password, Response: nofix ok
10.5 Remote immobilizing
Delayed immobilizing
Command: stop+password. When the current speed of the vehicle is greater than 20km/h, the
command will not be executed immediately. it will be executed only after the vehicle speed is less
than 20Km/h.
Immobilizing immediately
Command: quickstop+password, no matter whether the vehicle speed is greater than 20km/h, the
command will be executed immediately.
Resume fuel and power supplying
Command: resume+password, restore fuel and power supply.
10.6 Arming/disarming
Arming: arm+password, Response
：
Tracker is activated, the vehicle terminal enters the armed state.
If the vehicle is in the ignition state (i.e. ACC is ON), it cannot enter the armed state, and then reply
“set up fail! pls turn off ACC”.
Silent arming: silent+password, Response
：
silent ok!, the terminal enters the silent arming state.
After the alarm is triggered, the siren does not sound, but an alarm text message will be sent to the
authorized number.
Disarming: disarm+password, response: Tracker is deactivated, After disarming, the door, shock
sensor and ACC alarm will be deactivated.
10.7 Alarm function in arming state
10.7.1 Door Opening Alarm
When the door is opened in arming state, tracker will send SMS notification “Door alarm+latitude &
longitude” to authorized numbers. The siren will beep for 20 seconds, and if the door is still open,
then the siren will beep for another 20 seconds with 20 seconds pause, disarming to quit the alarm.
10.7.2 ACC Alarm
When the tracker is in the armed state, turn the starter key to the ACC ON position or start the
vehicle directly, it will send “ACC alarm + latitude / longitude” to authorized numbers and the siren
will sound for 20 seconds. And if the ignition is still on, then the siren will beep for another 20
seconds with 20 seconds pause, disarming to quite the alarm.
10.7.3 Shock Alarm
When the tracker is in the armed state, when the device moves or vibrates, it will send SMS
notification "Sensor alarm + latitude and longitude" to the authorized number. The vibration alarm
will only be sent once within 3 minutes. The siren will beep for 5 seconds for the first time within
three minutes of the vibration alarm. The siren sounds for 5 seconds and then sounds for 10 seconds.
Vibration sensitivity defaults to level 2, which can be set to 1, 2, or 3. Command:
sensitivity+password+space+2
To Next Page
Loading...
