DIGIMINI AMERICAS REPEATERS
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage Date: 6-Jul-17 www.cobham.com/wireless
Doc. No.: 00031UM Rev. 6.3
Page | 5-1
5 SETUP AND CONFIGURATION
NOTE: This section is relevant to installations that WITHOUT a DMCU. For installations with DMCU unit, refer
to the DMCU User Manual.
The Mini-Repeater is designed for simple plug-and-play operation, only requiring the setup of a number of
parameters (such as DL Output Power, bandwidth, and gain) through a local Web connection and verifying
that the system is operating properly.
The setup procedure consists of the following steps:
1. Open a local Web session to the Repeater.
If you are not familiar with the Cobham Wireless Web Access application, it is recommended to quickly
review the Navigating the Web GUI Application section.
2. Adjust the signal levels and configuring the sub-bands and verify that no Alarms are generated.
5.1 Open a Direct Local Web Session to the Repeater
NOTE: These instructions are valid only for installations
without
a DMCU.
The procedure consists of three steps:
• Connect the setup computer to the repeater’s Ethernet port.
• Configure the computer’s IP address to be in the same subnet as the repeater’s IP Address
• Login to the repeater
To Next Page
Loading...