98-145510-E 5-1
Chapter 5
Initial setup and basic functions
5
This chapter describes the initial setup and basic functions of the EXPLORER 8000 series
VSAT systems.
For information on configuration with the web interface and how to use the display and
keypad, see Setup and operation on page 6-1.
This chapter has the following sections:
• To drive with the antenna installed
• Prerequisites for installation
• Initial setup
• Start up and basic functions
5.1 To drive with the antenna installed
The antenna must be stowed when you drive the vehicle. The maximum speed depends on
your installation, but it must never exceed 130 km/h.
5.2 Prerequisites for installation
5.2.1 Location for transmission
Line of sight
Make sure the vehicle with the VSAT system is parked where there is free view to as much
of the sky as possible.
If possible, park the vehicle in such a way that the antenna, when deploying, points in the
approximate direction of the satellite. This is to avoid excessive movements of the
antenna and to improve the acquisition time. If the satellite elevation is close to
Zenith, the antenna elevation angle should preferably be less than 82 degrees.
Space for antenna movement
Make sure the vehicle is parked in a place where the antenna can move freely in all
directions, according to the Stay clear areas shown in Figure 3 on page vi and Figure 4 on
page vii.
WARNING! Incorrect installation of the antenna may cause the antenna to
fall off the vehicle or stress the mounting base. Thrane & Thrane A/S assumes
no liability for any damage caused by the antenna falling off the vehicle or
stressing the mounting base. It is the responsibility of the customer to ensure a
safe and correct installation of the antenna. The instructions in the Installation
manual are only guidelines.
To Next Page
Loading...
