98-145510-E 6-1
Chapter 6
Setup and operation
6
This chapter has the following sections:
• The web interface
• Keypad and display menus
• SNMP support
6.1 The web interface
The VSAT system has a built-in web interface, which has two levels:
• Mobile web interface, used for basic operations and status. Accessed from a
smartphone or tablet.
• Configuration web interface, used for configuration, line-up, troubleshooting,
extended status information etc. Accessed from a computer.
6.1.1 Mobile web interface
When you access the web interface from a smartphone or tablet you get access to the
mobile web interface, which offers the following basic operations and status:
• Deploy, stow and stop the antenna
• Activate satellite profile
• See status and events
• Access the configuration web interface
To access the mobile web interface of the ACU
1. Power up the VSAT system, i.e. switch on the ACU. Wait until the LEDs on the front plate
of the ACU show that the system is ready to be accessed.
•Power LED: Green
• Fail/Pass LED: Steady green.
2. Connect your smartphone or tablet to the WLAN of the ACU. For details on WLAN
setup, see WLAN settings on page 6-16.
3. Open your Internet browser and enter the IP address of the ACU. The default IP address
is http://192.168.0.1.
To Next Page
Loading...
