The web interface
98-145510-E Chapter 6: Setup and operation 6-17
6.1.9 Navigation
On this page you can enter a fixed position or a fixed base heading. Do as follows:
1. Select SETTINGS > Navigation from the left navigation pane.
2. Set the Heading (Compass direction) and Position.
3. Click Apply for each of the new settings.
6.1.10 Email setup
To be able to send diagnostics reports and other system information using e-mail you must
set up a couple of parameters. Contact your IT department for the specific data.
To configure the e-mail setup, do as follows:
1. Select SETTINGS > E-mail setup from the left navigation pane.
2. Enter the data for Outgoing mail server (SMTP), SMTP port number, SMTP
authentication, User name and password. This data is typically provided by your IT
department.
Item Description
Heading
(Compass
direction)
Automatic - magnetic heading is used (default setting).
Manual - enter a value for the direction of the antenna as an
alternative to the magnetic heading (0 to 360 degrees, precision ±20°.
0 degrees is North).
Position GNSS - GNSS module is used for current position (default setting).
Manual - enter values from other position source. (Accuracy should be
better than 50 m.)
Table 6-12: Web interface: SETTINGS > Navigation
You must set Outgoing mail server to an IP address if DNS has not been set
up in DNS setup in To configure the LAN network on page 6-14.
To Next Page
Loading...
