The web interface
98-145510-E Chapter 6: Setup and operation 6-18
6.1.11 Reports, syslog and SNMP traps
You can set up the system to send the following reports and messages:
•Diagnostics report
•Remote syslog
•SNMP traps
To send a diagnostics report
You can send automatically generated diagnostic reports at fixed intervals. The diagnostic
report contains information relevant for the service personnel during troubleshooting. To
set up sending a diagnostics report, do as follows:
1. Select SETTINGS > Reporting from the left navigation pane.
2. Under Diagnostics report, enter the following:
•E-mail sender
• E-mail recipients (comma separated)
•Send interval: Select e-mail disabled (default), day with 2-minute samples, week
with hourly samples or month with hourly samples. The report contains statistics
data for the selected intervals.
3. Click Apply.
You can also send the report at any time by clicking Send now. Use Send now to validate
the e-mail setup. See also Help desk and diagnostics report on page 7-2.
Remote syslog
You can set up the antenna to send each syslog message to a syslog server to advise the
system administrator of the current status of the antenna.
To set up sending syslog messages to a syslog server, do as follows:
1. Select SETTINGS > Reporting.
2. In the section Remote syslog select On to enable remote syslog (default: Off).
3. Enter the IP address of the syslog server to which the syslog messages will be sent.
4. Click Apply.
SNMP traps
SNMP traps, or notifications, are network packets which advise the system administrator
about significant events in the antenna, e.g. alarms and system error messages. They are
generated by the antenna and can be sent automatically to an SNMP trap
receiver/manager).
You must first set up the Email. See the previous section, Email setup.
Note that the diagnostics report also shows the WLAN key.
To Next Page
Loading...
