General support
98-145510-E Chapter 7: Service and maintenance 7-3
The Event list page shows a detailed list of active events and notifications including the
time of the first occurrence, ID and severity of the event message, and a short text
describing the error. Active events are cleared from the event list when the error is cleared.
They are moved to the section Notifications and are displayed for 24 hours. All entries in
the section Notifications are deleted automatically after 24 hours and after restart of the
system. For a list of all events with description, error code (ID), explanation and remedy see
System messages on page E-1.
7.1.4 Self test
You can start a self test of the antenna and ACU.
1. Select SERVICE > Self test.
2. Select
Restart antenna or Restart terminal, depending on whether you want to
test the antenna alone or the system.
7.1.5 Restart
To restart the system do the following:
1. Press and hold and until the ACU display shuts down and the antenna reboots.
2. Wait until the antenna has rebooted and is operational again. The last active satellite
profile will be used.
If you want to reset the VSAT system to factory defaults, see Reset to factory default on
page 6-26.
The VSAT system will reboot to perform the self test. Rebooting the
ACU will terminate all existing connections.
Figure 1: To restart the system
To Next Page
Loading...
