The web interface
98-145510-E Chapter 6: Setup and operation 6-26
6.1.19 Reset to factory default
To reset to factory default settings, do as follows:
1. Select ADMINISTRATION > Factory default.
• Navigation settings
• All added satellite profiles
• All added modem profiles
• Changes in the network setup
• User permissions
• ACU display: brightness setting
2. Click Reset to factory default.
6.1.20 Help desk
The Help desk pages in the web interface are described in the Service chapter under Help
desk and diagnostics report on page 7-2.
Reset to factory default will delete or reset all the settings listed
below!
After resetting to factory default: When you power on the system, make sure
the antenna is connected to the ACU. If not, the list of available modem types
under SETTINGS > Modem profiles may not be correct, because the ACU
cannot determine whether the antenna type is Ka or Ku.
To Next Page
Loading...
