The web interface
98-145510-E Chapter 6: Setup and operation 6-25
functions and make these pages read-only. This is useful if you want to protect the system
against unintended changes or tampering of the system.
To set up the user permissions for guest users, do as follows:
1. Select ADMINISTRATION > User permissions.
2. For each item under ALLOW USERS TO: select
• Yes to allow the guest user access
• No to block the guest user access to the settings. Then the pages are read-only,
changes cannot be made by the guest user.
Change network: Locks the page SETTINGS > Network. Use this page to change IP
configuration of the LAN connectors of the ACU. For further information see To
configure the LAN network on page 6-14.
3. Click Apply.
6.1.18 To import and export a system configuration
If you need to reuse a configuration in another VSAT system, you can save the current
configuration to a file, which can then be loaded into another VSAT system. You can also
use this feature for backup purposes.
The configuration file contains all the settings you have entered during system setup:
satellite profiles, modem profiles, LAN setup, user permissions etc.
To save a configuration to a file, do as follows:
1. Select ADMINISTRATION > Export/import config.
2. Click the button Export. Follow the download instructions on the screen. You can use
this configuration file for upload to another VSAT system,
To load a configuration from a file, do as follows:
1. Select ADMINISTRATION > Export/import config.
2. Click the button Browse and locate the configuration file (.cfg file) you want to upload.
Then click the button Open.
3. In the web interface click the button Upload.
To clone a system configuration, do as follows:
1. Reset to factory default, see the following section for details.
2. Import a configuration from file, see section above.
Study this screen thoroughly and decide which areas of the VSAT system
you want to give non-administrator users (user name: guest) access to.
Load and save configurations can only be done with the same software
version in the units involved.
To Next Page
Loading...
