Chapter 2: Installation
98-141368-A 17
Install the terminal
Ground the terminal
Antenna cable
The antenna ground is connected to the terminal ground by means of the coax cable with a
TNC connector at both ends.
For information on antenna grounding, see Ground the antenna on page 13.
Ground stud
To ensure that the terminal is grounded – also if the cable is disconnected from the terminal,
connect an extra ground wire to the ground stud on the terminal. This ground wire must be a
heavy wire or braid cable with a larger diameter than the coax cable. The ground stud is located
next to the power switch.
To Next Page
Loading...