2110 SSB Transceiver Getting Started Guide 49
CODAN
Appendix B—Using Quick Start
Quick Start provides simple methods to configure your
transceiver to a basic operating state.
Quick Start will be available if your transceiver contains only
one station self address and network names from this default
list:
•*Voice
• *Selcall
•*CALM
•!Default
Opening and closing Quick Start
To open Quick Start:
1 Hold .
To close Quick Start:
1 Press or hold .
NOTE
When you hold , you should see the Quick
Start entries, for example, Add/Edit channel,
Set scan list etc. If these entries are not
displayed, then Quick Start is not available to
you.
Quick Start is not available in countries that do
not permit programming of transmit frequencies
using the front panel, for example, the United
States of America and Australia.
For detailed information on programming your
transceiver without Quick Start see the
reference material on the enclosed CD.
To Next Page
Loading...
Need help?
General
