Code Blue IP2501-s - 9 Factory Reset

Code Blue
•
259 Hedcor Street
•
Holland, MI 49423 USA
•
800.205.7186
•
www.codeblue.com
GU-137-Hpage 47 of 67
IP1500 and IP2500 Series
Administrator Guide
9 Factory Reset
Thesystemcanberesetviatwodifferentmethods.
1st Method:
Thespeakerphonecanberesetbyfollowingthestepsbelow:
Usethe7pinresetplug(sentwithyourorder)inordertoperformafullreset.
4&5LongReset=HardReset,setseverythingbacktodefault
2&3ShortReset=Resetsnetworkconguration
• UnplugtheRJ45fromthePoEswitchport
• UnplugbuttonanddisconnecttheLEDharness
• Shorttheappropriate2pinstogetherforshortorlongreset(seepicbelow)
• PlugtheRJ45backintothePoEswitchport
• Uponhearingtwoshortbeeps,unithasbeenreset
• Wait10secondsforphonetoreboot
• Unplugpowersource
• Removethejumperandreconnectthebuttons
• Reconnect7pinharness
• Reconnect PoE
TheResetisnowcomplete.
(Continued on next page)