(c) Software Version
These displays indicate the version of the software installed on the Controller Board.
(Program + EPROM = Firmware.) The firmware version should be quoted when seeking
advice.
(d) FRAM Faults
This checks to see how many times the program has tried to write to the FRAM
Memory should always been at (0), this is a program to check for faults that are
occurring in the machine.
Set Dry Vends
10. Entering SET DRY VENDS provides access to the following sub-menu:
• VENDS ARE WET
• VENDS ARE DRY
(a) Vends are WET
All vends are dispensed with water as normal.
(b) Vends are DRY
All vends are dispensed without water. This allows ingredients to be weighed. If a multi-
ingredient drink is selected, only those ingredients will be vended.
To Next Page
Loading...
Need help?
General