Section 4
Installation & Commissioning
INTRODUCTION
1. The information given in this Section covers installation, commissioning and maintenance
procedures for the Neo beverage machine. Authorised personnel, who are fully conversant
with the equipment, using only the manufacturers approved parts, must carry out these
procedures.
2. Servicing personnel must be familiar with the SAFETY WARNINGS listed on page 81
before undertaking any installation, commissioning or maintenance procedure on the
beverage machine. Any procedure, which is found to be impracticable, inadequate or
inaccurate, should be reported to the Management for further investigation.
3. The requirements of proper hygiene in respect of food products must be ensured at every
level of contact with the beverage machine and the ingredients associated with it.
To Next Page
Loading...
Need help?
General