Possible values are YES and NO. When set to YES, change will not
be given until a vend cycle has taken place.
Possible values are SINGLE VEND and MULTI VEND. When set to
MULTI VEND, change will only be paid in response to depression of
the escrow lever. When set to SINGLE VEND, change will be given
automatically following the vend cycle or in response to depression of
the escrow lever.
If a multi session capable card reader is fitted, setting MULTI VEND
has the effect of allowing several vends to be taken without removing
the card. Note: The reader must be multisession capable, and
most are not!
AUTO CONFIGURE
ACCEPTANCE MASKS
This is a function rather than a setting. It is only available if an MDB
Changer is fitted. If successful, it will interrogate the reader and set
up the ENABLED NORMAL and ENABLED EXACT CHANGE
MASKS. If no device is found, the message CONFIG FAILED, and a
depressing beep will occur.
ENABLED COINS
EXACT CHANGE
This variable controls which coins are accepted in circumstances
where the exact change message would be displayed. The MBD
protocol provides for up to 16 coins. For the purposes of enabling or
disabling acceptance, the coins are represented by the letters A
through to P, with A being the least value coin. The acceptance
status of each coin is shown by a 1 or 0 below the corresponding
letter. One indicates acceptance and zero - rejection.
Applied to a silver only changer with 5, 10, 20 & 50p coin tubes the
above setting will enable acceptance of the 5, 10 & 20p coins.
This variable controls which of the coins that an attached changer is
programmed to accept should actually be accepted in normal
operation, i.e. other than exact change mode. For the purpose of
changing the coins to be accepted the procedure is the same as for
Enable Coins Exact Change above.
ENABLE BILLS EXACT
CHANGE
This variable controls which notes are accepted in circumstances
where the exact change message would be displayed. For the
purposes of enabling or disabling acceptance, the notes are
represented by the letters A through to P, with A being the least value
coin. The acceptance status of each note is shown by a 1 or 0 below
the corresponding letter. One indicates acceptance and zero -
rejection.
This variable controls which of the notes that an attached changer is
programmed to accept should actually be accepted in normal
operation, i.e. other than exact change mode. For the purpose of
changing the notes to be accepted the procedure is the same as for
Enable Bills Exact Change above.
PONMLKJIHGFEDCBA
00000000000000000111
PONMLKJIHGFEDCBA
00000000000000000000
To Next Page
Loading...
Need help?
General