1. ADV MODE ENABLE
Activates/Deactivates advanced mode. The remaining options in this menu are
unavailable while advanced mode is inactive.
2. SET LEARN MODE
Configures the machine to 'learn' when the machine is used and set up advanced
mode accordingly. This is achieved by counting the number of vends taken in each
15-minute period, and, if they exceed a given threshold figure, setting the override ON
for that period. This process can take place over a period of up to three weeks, with
the result (ON/OFF) from previous week(s) being factored in, depending on the
settings made in the following process:
• If a learning process is already in progress, this will have to be cancelled before a
new one can be set up.
• SET NO OF WEEKS - select a learning process of 1, 2- or 3-week duration.
• If 2 or 3 weeks selected, a WEEK 2 WEIGHTING will be required. This is a
percentage figure, determining how much importance is given to the existing
setting (i.e. the week 1 result: override ON or OFF) of the current 15-minute
period. This can be a value of 10%, 20%, 25%, 33% or 50%.
• If 3 weeks selected, a WEEK 3 INCREMENT will be required. This is a modifier
applied to the WEEK 2 WEIGHTING to (optionally) increase the influence of the
previous 2 weeks’ results in the final result. This can be an add-on value of +10%
or +20%, no increment, or a multiplication factor of 1.25, 1.5 or 2.0. For example,
if the week 2 weighting was 10%, and a multiplication factor of 1.5 was applied,
then the result after weeks 1 & 2 of the process would be given a weighting of
15% of the final determination of the setting.
• Finally, a THRESHOLD figure needs to be set. This is the number of vends
required in a 15-minute period for an override to be set.
• Once all settings have been entered, learning mode will be activated. It will cease
after the given number of weeks have elapsed, and from then on, the override
settings will not be automatically modified.
3. END LEARN MODE
This allows the learning process to be terminated early. No changes made to the
overrides whilst learning was active will be reversed, but no further changes will be
made.
4. MANUAL CONFIG
Allows manual editing of the advanced mode override periods, with each day
presented in 6 4-hour blocks of 16 15-minute periods. Each period is represented as
a value of 0 (Off) or 1 (On). For example, the override setting for 15.45-15.59 on a
Saturday would be represented by the right-most value in the block labelled SAT
1200-1559.
Periods which are marked with a '-', rather than a 0 or 1 are those in which economy
mode (as a timed activity) is not active, so editing these settings would have no effect.
Note that any manual changes made while the learning mode process is active will be
subject to modification by the learning algorithm.
5. CLEAR OVERRIDES
To Next Page
Loading...
Need help?
General