PLEASE INSERT
USB DEVICE
(9) Once a USB has been inserted the machine will recognise this and if the USB
contains EMCU firmware the machine will ask you to select a file eg.
SELECT FILE
NEO_V03.HEX
(10) Press enter on the appropriate file you wish to use. The machine will then
automatically run through a procedure to take the. HEX firmware file from the USB to
the flash memory chip
(11) Once finished the machine will prompt the USB to be removed, once removed the
machine will prompt the ENG LNK to be removed.
(12) Switch the machine off and put the ENG LNK only on one of the two pins leaving the
CLK BAT on both connections.
(13) At this point the machine is then ready for the second level of board set up; please
see below for this procedure.
4. The second level of programming involves setting up the board to operate the correct
predefined menu configuration for the machine to which it is fitted. The procedure to
achieve this is as follows:
(34) Turn on the power. The machine will start up in the standard vending mode.
(35) Enter the engineer’s mode by pressing the PROG button on the internal keypad and
use the engineers code (default 4444)
(36) The display will change to INGREDIENT TIMES.
(37) Scroll till the display shows CONFIGURE Machine, enter this and scroll again until
the display shows SET MACHINE TYPE and press enter.
(38) The only heading available under this menu is NEO CONFIGS so enter this heading;
now continue to scroll until you find your appropriate machine configuration and press
enter
(39) If the machine is fitted with a coffee brewer it will off the option to select the coffee
from bean or roast and ground (only select bean grinder if the machine is fitted with
such), after entering the brewer type you can select the extras as described in
Section 3.
(40) Once the machines default has been set enable the coin mech MDB protocol if a coin
/ card system is fitted via the SET CASH SYSTEM.
(41) After this has been set, escape one level and scroll until set date and time appears,
enter this heading and set accordingly.
(42) Set up the Operator and Manager level codes if different from the default.
(43) Finally adjust the drink settings as required and test each selection.
To Next Page
Loading...
Need help?
General