Cognex DM-280X - Industrial Protocols

Industrial Protocols
The reader supports the following industrial protocols:
l EtherNet/IP™, EDS and PLC
l PROFINET (Class B)
l SLMP Protocol
l Modbus TCP
l CC-Link
Select industrial protocol samples and tools you want to use when you install the DataMan Setup Tool.
There are three ways to enable or disable industrial protocols. Once enabled, a reboot is required for the changes to
take effect.
l Enable the protocols using the Industrial Protocols pane of the DataMan Setup Tool, under Communications.
l Scan the appropriate Reader Configuration codes. For more information, see Reader Configuration Codes
available through the Windows Start menu, the DataMan Setup Tool Help menu, or DataMan documentation
available on the Cognex support site.
l Send the appropriate DMCC command. For more information, see Command Reference available through the
Windows Start menu or the DataMan Setup Tool Help menu.
For more information on using the industrial protocols, see the DataMan Industrial Protocols Manual available through
the Windows Start menu, the DataMan Setup Tool Help menu, or DataMan documentation available on the Cognex
support site.
47
Using Your DataMan Reader