IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
This is maintenance countdown timer #1. The timer is located in setpoints (group
Engine protect) as well as in values (group Statistics). Adjust the timer to the
requested maintenance interval. It will be then decremented while the gen-set is
running. The alarm WrnServiceTime is issued as soon as the timer counts down
to zero.
Value: Service time 2
This is maintenance countdown timer #2. The timer is located in setpoints (group
Engine protect) as well as in values (group Statistics). Adjust the timer to the
requested maintenance interval. It will be then decremented while the gen-set is
running. The alarm WrnServiceTime is issued as soon as the timer counts down
to zero.
Value: Service time 3
This is maintenance countdown timer #3. The timer is located in setpoints (group
Engine protect) as well as in values (group Statistics). Adjust the timer to the
requested maintenance interval. It will be then decremented while the gen-set is
running. The alarm WrnServiceTime is issued as soon as the timer counts down
to zero.
Value: Service time 4
This is maintenance countdown timer #4. The timer is located in setpoints (group
Engine protect) as well as in values (group Statistics). Adjust the timer to the
requested maintenance interval. It will be then decremented while the gen-set is
running. The alarm WrnServiceTime is issued as soon as the timer counts down
to zero.
Value: TotalDownTime
To Next Page
Loading...
Need help?
General
