ComAp IG-NT - Page 256

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
256
Description
This counter counts while the controller is in "not ready" state, i.e. it can not be
started. The reason of the "not ready" state may be either some 2
nd
level alarm or
the controller switched in OFF mode.
NOTE:
The counter can be readjusted/reset from InteliMonitor menu Monitor -> Set
statistics.
Value: DnTimeReqToRun
Group
Statistics
Units
h
Related FW
3.0
Description
This counter counts while the controller is in "not ready" state (see the value Total
downtime) and there is a request for the gen-set to run.
NOTE:
The counter can be readjusted/reset from InteliMonitor menu Monitor -> Set
statistics.
Value: PulseCounter 1
Group
Statistics
Units
-
Related FW
3.0
Description
This is the value of PulseCounter #1 module. See the binary input PulseCounter
1.
Value: PulseCounter 2
Group
Statistics
Units
-
Related FW
3.0
Description
This is the value of PulseCounter #2 module. See the binary input PulseCounter
2.
NOTE:
Available in IS-NT only.
Value: PulseCounter 3
Group
Statistics
Units
-
Related FW
3.0
Description
This is the value of PulseCounter #3 module. See the binary input PulseCounter
3.