ComAp IG-NT - Page 294

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
294
ENCODING TABLE
LANGUAGE INDEX
INPUT A
INPUT B
INPUT C
0
0
0
0
1
1
0
0
2
0
1
0
3
1
1
0
4
0
0
1
5
1
0
1
6
0
1
1
7
1
1
1
NOTE:
"0" in the table means the input is not active or not configured.
NOTE:
Language index 0 selects the default language of the terminal, i.e. the language,
which is adjusted in the terminal using it's menus.
NOTE:
The reaction on changes of these inputs is delayed about 1 sec to ensure the new
combination is valid (e.g. if a rotary selector switch is used).
CAUTION!
Each language change causes the reinitialization of the display. Function of the
controller is not influenced.
Binary input: Lang sel int B
Related FW
3.0
Description
This is one of three binary inputs Lang sel int A, Lang sel int B, Lang sel int C,
used for selecting language of the built-in IG-NT terminal (display). As the IS-NT
does not have built-in terminal, this input is assigned to the terminal (display) #1,
which is supposed to be directly attached to the controller or mounted close to it.
NOTE:
Using these inputs for language selection is an option only. If the inputs are not
configured, the language can be selected using the menus on the terminal.
ENCODING TABLE
LANGUAGE INDEX
INPUT A
INPUT B
INPUT C
0
0
0
0
1
1
0
0
2
0
1
0
3
1
1
0
4
0
0
1
5
1
0
1