IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
If this setpoint is in ENABLED position the display backlight is temporarily
switched off during gen-set start.
Setpoint: FastHistPeriod
100 ms, 300 ms, 500 ms, 1 s, 3 s [-]
This setpoint adjusts the period with which fast history records are written. Fast
history is triggered if level 2 alarm (for more information on alarm levels please
refer to this section) is issued and the engine is running (at least one condition
from this list is fullfiled). For any setting of this setpoint Fast History contains 50
records.
Setpoint: ConvCoefPulse1
This setpoint adjusts the rate of increasing of the PulseCounter #1 module. The
module counts pulses at the input PulseCounter 1 and if the input pulses counter
reaches value given by this setpoint, the counter value PulseCounter 1 (in the
group Statistic) is increased by 1 and input pulses counter is reset to 0. Both
counter value and input pulses counter are stored in the nonvolatile memory.
Setpoint: ConvCoefPulse2
This setpoint adjusts the rate of increasing of the PulseCounter #2 module. The
module counts pulses at the input PulseCounter 2 and if the input pulses counter
reaches value given by this setpoint, the counter value PulseCounter 2 (in the
group Statistic) is increased by 1 and input pulses counter is reset to 0. Both
counter value and input pulses counter are stored in the nonvolatile memory.
Setpoint: ConvCoefPulse3
To Next Page
Loading...
Need help?
General
