ComAp IS-NTC-BB Reference Guide

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
206
For IS-NT only.
Setpoint: ExtValue1 rate
Group
Force value
Range [units]
1 .. 10000 [X/s]
Related FW
3.0
Force value
possible
YES
Force value
possible
YES
Description
This setpoint adjusts the rate pre second at which the ExtValue 1 is beeing
changed while the input ExtValue1 up or ExtValue1 down is active.
Setpoint: ExtValue2deflt
Group
Force value
Range [units]
-32000 .. 32000 [x]
Related FW
3.0
Force value
possible
YES
Force value
possible
YES
Description
This setpoint adjusts the reset (initial) value of the ExtValue 2. This initial value is
applied either when the controller is powered-on or when the ExtValue 2 is reset
by the binary input ExtValue2reset.
Setpoint: ExtValue2LoLim
Group
Force value
Range [units]
-32000 .. ExtValue2HiLim [X]
Related FW
3.0
Description
This setpoint adjusts the low limit of the value of ExtValue 2 if the value is
lowered/raised by the binary inputs ExtValue2 up and ExtValue2 down. The
ExtValue 2 is never lowered below this limit.
NOTE:
This limit is not taken into account if the value ExtValue 2 is written remotely from
a terminal using the appropriate command ExtValue #n.
NOTE:
For IS-NT only.
Setpoint: ExtValue2HiLim
Group
Force value

ComAp IS-NTC-BB Specifications

General

Brand	ComAp
Model	IS-NTC-BB
Category	Controller
Language	English