ComAp IS-NTC-BB Reference Guide

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
279
Binary input: Timer block 15
Related FW
3.0
Description
This input is used to disable temporarily the output from the Timer channel #15.
NOTE:
See also the setpoint TimerChannel 15 and output TimerAct 13-16.
NOTE:
See the chapter Timers for more details about timers.
Binary input: Timer block 16
Related FW
3.0
Description
This input is used to disable temporarily the output from the Timer channel #16.
NOTE:
See also the setpoint TimerChannel 16 and output TimerAct 13-16.
NOTE:
See the chapter Timers for more details about timers.
Binary input: ExtValue1 up
Related FW
3.0
Description
For IS-NT only.
While this input is active the value of ExtValue 1 is contiously beeing increased at
the rate of ExtValue1 rate until it reaches ExtValue1HiLim.
NOTE:
If this input is used (configured), the ExtValue 1 can't be written remotely from a
remote terminal using the command ExtValue 1.
Binary input: ExtValue1 down
Related FW
3.0
Description
IS-NT specific function
While this input is active the value of ExtValue 1 is contiously beeing decreased at
the rate of ExtValue1 rate until it reaches ExtValue1LoLim.
NOTE:
If this input is used (configured), the ExtValue 1 can't be written remotely from a
remote terminal using the command ExtValue 1.
Binary input: ExtValue2 up
Related FW
3.0
Description
For IS-NT only.

ComAp IS-NTC-BB Specifications

General

Brand	ComAp
Model	IS-NTC-BB
Category	Controller
Language	English